Temperature Probe for Photovoltaics – Temmeter
Last update
Temmeter is a highly resistant temperature Probe for photovoltaic modules (solar panels), based on a PT100 temperature sensor. It has strong adhesive fixing for quick and easy installation. Adhesive fixing makes it more economical than Temmeter PRO, without sacrificing efficiency. Temmeter is an easy-to-install PT100 thermal sensor that does not require a mounting system, as it has a powerful adhesive surface. The white non-hygroscopic plastic casing is resistant up to 130°C; shows neutral behavior in temperature measurement even in the presence of direct radiation on the sensor.
Note: Solar modules exposed to high temperature produces less power than same module at 25°C. Correct Performance Ratio (P/R) calculation requires the correct formula. In Southern Europe PV module temperatures can reach 85°C during Summer; in those cases the loss of output power are lower of around 25%!
Soluzione Solare temperature probes are designed for outdoor use and quick response to temperature variations (from several milliseconds to a few seconds) in order to ensure precise Performance Ratio calculations.
Key features
- Fast speed of response to temperature variation (under 5 seconds, high thermal transmittance).
- Strong adhesion even to surfaces with low surface tension such as Tedlar.
- Measurement precision is above the required standards (PT100 class A sensor).
- Protected cable.
Note: please remember that for accurate temperature measurements of your solar panels, ensure your are measuring the temperature of a representative module of the plant.
Datasheet
NAME | TEMMETER | |
PRODUCT | Temperature Probe for solar panels | |
REFERENCE STANDARD | IEC 60751 (class A), DIN43760 (KL. A) | |
OUTPUT | (Analogical) Impedance Variation (PT100 Δ ± 0.3°C) | |
Sensor casing | White plastic anti-shock, with neutral thermal behavior at direct irradiation | |
Type of sensor | Platinum Thermal Resistor PT100 class A placed to ensure high heat transmittance | |
Temperature range | -40 ÷ +120°C | |
Precision | ± 0.25°C | |
Accuracy | ± 0.3 | |
Response time | < 15 seconds when temperature is rising < 45 seconds when temperature is falling | |
Adhesive material | 0.4mm thick, suitable for sticking to tedlar and plastic materials with a flat surface and low-medium surface tension | |
Cable | 1,25m with 2/3 poles, shielded, with with external insulation. UV and temperature proof | |
Connector | M8 a 3 poles IP67 / loose pins (white – red)** | |
PT100 dimensions | 25mm diameter, 4.5mm average height |